Series 90-70 Modules Compatibility with Rx7i ka21t0000008Xf4AAE | Emerson Customer Center

Series 90-70 Modules Compatibility with Rx7i

Description

Hardware Main, Expansion and Firmware Requirements

Resolution

90-70 GBC IC697BEM731SBS3* and B or higher, B or higher, 5.8 or higher
90-70 PCM IC697PCM711SBS3* and PCMA1 R05 or higher, PCMA1 R05 or higher, 4.05 or higher
90-70 CMM IC697CMM711SBS3* and PCMA1 R05 or higher, PCMA1 R05 or higher, 4.20 or higher
90-70 DLAN IC697BEM763SBS3* and G01R03 or higher, Not allowed 3.00 or higher
90-70 High Speed CounterSBS3* and A or higher, A or higher, 1.21 or higher
IC697HSC700
90-70 Analog InputSBS3*, and A or higher A or higher 1.6 or higher
IC697ALG230
90-70 Analog OutputSBS3*, and E or higher C or higher 1.4 or higher

*SBS3. All modules installed in the RX7i main rack that use the SBS VME interface chip are required to have version 3 of the chip. To determine whether your module meets this requirement, look at the large square ASIC located near the top right corner of the circuit board. The chip must have the following markings. The most critical items are the last two lines: "SBS3" and "454-3". (GE started shipping modules with SBS3's in 1998.)